![]() ![]() ![]() The CMM would compare the 3D scan of the profile to the dimensions called out on the drawing to see if it was in spec. Profile is usually measured using a CMM due to the complexity of some of the surfaces that are called out. This tolerance zone may or may not be referenced by a datum. GD&T Tolerance Zone:ģ-Dimensional tolerance zone existing of 2 parallel surface curves that follow the contour of the surface profile across the entire length of the surface. Usually, when surface profile is required, there are no tolerances on the dimensions that describe the surface and use the GD&T callout to give the acceptable range. Any point on the surface would not be able to vary inside or outside by more than the surface profile tolerance. Profile controls all the points along the surface within a tolerance range that directly mimics the designed profile. If it is called out on a curved surface, like a fillet on a welded part, the entire surface where the radius is has to fall within the tolerance zone. Profile of a surface describes a 3-Dimensional tolerance zone around a surface, usually which is an advanced curve or shape. GD&T Symbol: Relative to Datum: Optional MMC or LMC applicable: No Drawing Callout: ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |